Remote RT-1 EURO-CODE

Garage controls with installer code

This installer code for the garage controls is found in the signal receivers, but not necessarily every command has an installation code. It is a custom installer code, used by companies that provide the service of installation and maintenance of garage doors in neighborhood communities, so that only they can provide new commands and can reset the coding if necessary . Normally private homes do not have an installer code, being more common in the garage doors of neighborhood communities.

How to know if my garage remote has installer code?

To know if our garage control is personalized, we must ask our administrator of the community of neighbors, and in case you did not know, you should consult the maintenance company.

If in fact the answer is yes, we can not buy a garage remote anywhere except to them, although you can also clone the controls. That is, with a command that works with that installer code, you can take it to a site specialized in cloning garage controls, where they have a programmer for that type of command. In this way, it can be cloned from one command to another.

Can I buy a garage remote if my door has an installer code?

You can buy it, but it will not work, not programming it in the conventional way. You will have to take it to the maintenance company of your garage door and almost with total security, the company will charge you for programming it.

If the administrator knows the installer code, it is also possible to acquire a command to a specialized company that has a programmer, providing them with this code.

Why do they put installer code on garage doors?

The code is set for two reasons:

• So the maintenance company makes sure that nobody touches their garage door receivers, since no neighbor can program the controls.
• And on the other hand, they also ensure the sale and supply of garage controls.